COMTEC HDROP-05 Parking Surveillance Direct Wiring Unit Instruction Manual

1. Introdução

The COMTEC HDROP-05 is a direct wiring unit designed to enable parking surveillance functionality for compatible COMTEC drive recorders. This unit provides continuous or intermittent power supply to your drive recorder, allowing it to record events even when your vehicle is parked. It features a built-in G-sensor to detect impacts and ensure recording during critical moments. By connecting directly to your vehicle's ACC or IG line, it offers a clean installation without using the cigarette lighter socket.

Importante: This product is designed exclusively for use with compatible COMTEC drive recorders. Connecting it to other products may result in malfunction or damage. Please verify compatibility on the COMTEC official weblocal antes de usar.

2. Principais características

• Gravação estendida: Enables up to 12 hours of parking surveillance recording.
• Detecção de impacto: Built-in G-sensor ensures power supply and recording when an impact is detected.
• Customizable Operation: Settings for continuous operation time, intermittent operation time, and impact-only power supply can be configured via DIP switches on the main unit.
• Direct Power Connection: Connects directly to the vehicle's ACC or IG line for a tidy installation, eliminating the need for the cigarette lighter socket.
• Proteção da bateria: Automatically stops operation if the vehicle battery voltage drops below a set level, preventing battery drain.
• Gestão de gravações: In parking surveillance mode, if an impact is detected, the mode will end 5 minutes after detection to protect recorded data from being overwritten. This setting can also be adjusted to prevent termination. Older footage is automatically overwritten when the recording limit is reached.

3. Configuração e instalação

The HDROP-05 unit is designed for direct wiring to your vehicle's electrical system. Professional installation is recommended to ensure correct wiring and prevent damage to your vehicle or the unit.

3.1 Conexões de Fiação

• Cabo de alimentação: Approximately 5 meters in length.
• ACC Power Cable: Approximately 1.3 meters in length. Connects to the vehicle's Accessory (ACC) power line.
• Constant Power Cable: Approximately 1.3 meters in length. Connects to a constant power source in the vehicle.
• Ground Terminal Cable: Approximately 1.0 meter in length. Connects to a suitable ground point on the vehicle chassis.

Ensure all connections are secure and properly insulated. Refer to your vehicle's service manual for identifying appropriate ACC, IG, and ground points.

3.2 Produto Acimaview

This image shows the COMTEC HDROP-05 direct wiring unit. It is a compact device designed to manage power supply for parking surveillance. The unit typically includes various cables for connection to the vehicle's electrical system, such as ACC, constant power, and ground wires. The main body houses the control circuitry and DIP switches for configuration.

4. Instruções de operação

4.1 Parking Surveillance Modes

The HDROP-05 allows your compatible COMTEC drive recorder to operate in various parking surveillance modes:

• Operação contínua: The drive recorder records continuously for a set duration after the vehicle is turned off.
• Operação intermitente: The drive recorder records in intervals for a set duration.
• Impact-Only Recording: The drive recorder remains in standby and only begins recording when an impact is detected by the built-in G-sensor.

4.2 Configurações do interruptor DIP

The specific settings for continuous operation time, intermittent operation time, and impact sensitivity are configured using the DIP switches located on the HDROP-05 unit. Refer to the detailed instructions provided with your COMTEC drive recorder or on the COMTEC website for the exact configuration of these switches to match your desired parking surveillance mode.

4.3 Gerenciamento de Gravação

• Impact Event Protection: If an impact is detected during parking surveillance mode, the system is designed to terminate parking surveillance 5 minutes after the impact event. This measure helps prevent critical impact footage from being overwritten by subsequent recordings. This termination setting can be adjusted if continuous recording after impact is preferred.
• Automatic Overwrite: When the storage capacity of the drive recorder's memory card is full, the oldest recorded data will be automatically overwritten to make space for new recordings.

5. Manutenção

The HDROP-05 unit utilizes your vehicle's constant power supply, which places a load on the vehicle battery. To ensure optimal performance and prevent unexpected battery issues, it is crucial to:

• Regularly Inspect Vehicle Battery: Have your vehicle battery inspected periodically by a qualified technician.
• Monitore a saúde da bateria: Pay attention to any signs of battery weakness, especially during cold weather or if the vehicle is not driven frequently.

6. Solução De Problemas

6.1 Unit Not Operating / Drive Recorder Not Recording

• Bateria Voltage Proteção: The unit is equipped with a battery protection function. If the vehicle battery voltage drops below the preset threshold, the unit will automatically stop operation to prevent complete battery drain. Check your vehicle's battery health.
• Incorrect DIP Switch Settings: Verify that the DIP switches on the HDROP-05 are configured correctly for your desired parking surveillance mode. Refer to the operating instructions.
• Conexões soltas: Check all wiring connections (ACC, constant power, ground) for looseness or corrosion.

6.2 Vehicle Battery Drain

While the HDROP-05 has a battery protection feature, prolonged use in certain conditions can still lead to battery drain. Refrain from using the parking surveillance function under the following circumstances:

• If you do not drive your vehicle daily.
• If your daily driving duration is less than 1 hour.
• If your vehicle battery has been in use for more than 1 year.

COMTEC is not responsible for vehicle battery drain. Regular battery inspection is recommended.

7. Especificações

8. Garantia e Suporte

8.1 Compensation Service

This product includes a unique compensation service. In the event of an accident, COMTEC will pay a flat rate of 20,000 JPY as condolence money for one year from the date of registration. Please note the following conditions:

• This service is only applicable when used in combination with a compatible COMTEC drive recorder.
• The compensation service will not be available if the product is not registered within one month of purchase.

For full details and terms of the compensation service, please visit the official COMTEC website.

8.2 Official Support

For further information, compatible products, and detailed support, please visit the COMTEC official website:

http://www.e-comtec.co.jp

A warranty certificate is included with the product.