Gerador inversor silencioso portátil a gás Pulsar de 2,400 W

Introdução

This manual provides comprehensive instructions for the safe and efficient operation, maintenance, and troubleshooting of your Pulsar GD240N portable inverter generator. Please read this manual thoroughly before operating the generator to ensure proper usage and longevity of the product.

Principais características:

• 2400W starting watts, 1800W running watts
• Type A & Type C USB ports
• Operação super silenciosa
• Three-in-one switch for simplified control
• Parallel capability to combine with another unit for increased power output
• Enhanced fuel efficiency

Informações de segurança

PERIGO: Perigo de Monóxido de Carbono

Using a generator indoors WILL KILL YOU IN MINUTES. Generator exhaust contains poisonous carbon monoxide gas that can cause unconsciousness or DEATH. Operate in well-ventilated, outdoor areas away from open windows or doors. Point exhaust away from occupied areas. Do not run generator in enclosed areas (e.g., not in house or garage). Move to fresh air and get medical help if sick, dizzy, or weak.

Always ensure the generator is placed on a level surface and away from any flammable materials. Keep children and pets away from the operating unit.

Conteúdo da embalagem

Your Pulsar GD240N generator package includes the following items:

• Pulsar GD240N Portable Inverter Generator
• Manual do Proprietário
• Funil de óleo
• Basic Tool Kit (screwdriver)

Configurar

Adicionando óleo do motor

Before starting the generator for the first time, you must add engine oil. The generator is shipped without oil.

1. Locate the oil fill cap on the side of the generator.
2. Remove the side panel by unscrewing the two screws.
3. Remova a tampa de abastecimento de óleo / vareta medidora de nível.
4. Using the provided funnel, carefully add 5W-30 engine oil until it reaches the upper mark on the dipstick. The oil capacity is approximately 0.33 - 0.35 US Quarts (11.2 oz).
5. Replace the oil fill cap and secure the side panel.

Image: Locating the oil fill cap and adding 5W-30 engine oil to the Pulsar GD240N inverter generator.

Adicionando combustível

Use only fresh, unleaded gasoline with an octane rating of 87 or higher. Do not use E85 fuel.

1. Certifique-se de que o gerador esteja em uma superfície nivelada e que o motor esteja desligado e frio.
2. Desaparafuse a tampa do combustível.
3. Carefully fill the fuel tank (capacity 1.18 Gallons) with gasoline, leaving a small air gap at the top to allow for fuel expansion.
4. Recoloque a tampa do tanque de combustível firmemente.

Sobre os controlesview

Familiarize yourself with the control panel located on the front of the generator:

• Chave do motor: A three-in-one switch for OFF, RUN, and CHOKE positions.
• Interruptor do Modo Eco: Activates or deactivates Eco mode for improved fuel efficiency and quieter operation under light loads.
• Tomadas CA 120V 20A: Two standard household outlets.
• AC 120V 30A Outlet: For higher power demands (e.g., RVs).
• Portas USB: Includes Type A and Type C ports for charging electronic devices.
• Tomada CC 12V: For 12-volt DC appliances.
• Circuit Breaker/Reset Button: Resets the circuit in case of an overload.
• Parallel Connection Ports: Allows connection of two compatible generators for increased power.
• Luzes indicadoras: Displays status for Low Oil, Overload, and Output.

Imagem: Detalhada view of the Pulsar GD240N control panel, showing AC outlets, USB ports, DC 12V outlet, and various switches and indicator lights.

Instruções de operação

Iniciando o gerador

1. Certifique-se de que o gerador tenha óleo e combustível suficientes.
2. Gire a válvula de combustível para a posição 'LIGADO'.
3. Move the engine switch to the 'CHOKE' position (if the engine is cold).
4. Puxe firmemente a alavanca de arranque retrátil até o motor ligar.
5. Once the engine starts, gradually move the engine switch to the 'RUN' position.
6. Deixe o gerador aquecer por alguns minutos antes de conectar as cargas elétricas.

Image: The side of the Pulsar GD240N generator showing the engine switch in the 'RUN' position.

Modo Eco

The Eco Mode switch allows the generator to adjust engine speed based on the load, optimizing fuel consumption and reducing noise levels. For light loads, switch to 'ON' for quieter and more efficient operation. For heavy loads or when starting high-demand appliances, switch to 'OFF' to ensure full power is available.

Conectando dispositivos

Connect your electrical devices to the appropriate outlets on the control panel. Ensure that the total wattagA potência dos dispositivos conectados não excede a potência de funcionamento do gerador.tage (1800W) para evitar sobrecarga.

Operação Paralela

The Pulsar GD240N is equipped with parallel connection ports, allowing you to link two compatible Pulsar inverter generators together to double your power output. Refer to the parallel kit's instruction manual for detailed connection procedures.

Manutenção

Regular maintenance is crucial for the optimal performance and longevity of your generator. Always ensure the engine is off and cool before performing any maintenance.

Troca de óleo do motor

Change the engine oil after the first 20 hours of use or the first month, whichever comes first. Subsequent oil changes should be performed every 100 hours or every 6 months.

1. Coloque um recipiente adequado sob o bujão de drenagem de óleo.
2. Remova o bujão de drenagem do óleo e a tampa de enchimento de óleo para permitir que o óleo escorra completamente.
3. Once drained, replace the oil drain plug.
4. Refill with fresh 5W-30 engine oil as described in the 'Adding Engine Oil' section.

Spark Plug Access

The spark plug is accessible for inspection and replacement. Remove the spark plug cover to access the spark plug. Inspect the spark plug for wear and proper gap. Replace if necessary.

Corta-faíscas

The generator is equipped with a spark arrestor, making it US Forestry approved. Regularly inspect and clean the spark arrestor to prevent carbon buildup, which can restrict exhaust flow and affect performance. Refer to the owner's manual for detailed cleaning instructions.

Imagem: Traseira view of the Pulsar GD240N generator, highlighting the exhaust port and spark arrestor.

Solução de problemas

If your generator experiences issues, consult the following common troubleshooting tips:

Luzes indicadoras

• Luz de óleo baixo: If illuminated, check and add engine oil. The generator may shut down automatically to prevent engine damage.
• Luz de sobrecarga: If illuminated, the generator is overloaded. Disconnect some devices and press the reset button.
• Luz de saída: A green light indicates normal power output.

Problemas comuns

• O motor não liga: Check fuel level, oil level, spark plug, and ensure the engine switch is in the correct position.
• Sem saída de energia: Check for tripped circuit breakers, ensure the generator is not overloaded, and verify all connections.

Especificações

Garantia e Suporte

Informações de garantia

This Pulsar GD240N inverter generator comes with a 2-Year Manufacturer's Warranty. Please retain your proof of purchase for warranty claims.

Suporte ao cliente

For technical assistance, warranty inquiries, or to order replacement parts, please contact Pulsar Products customer support. Refer to the official Pulsar webPara obter os detalhes de contato, consulte o site ou a documentação da sua compra.