Informações importantes de segurança
Please read all instructions carefully before using the DAYTECH DA10 Fridge and Freezer Door Alarm. Retain this manual for future reference.
- Este dispositivo é destinado somente para uso interno.
- Não exponha o dispositivo a temperaturas extremas, luz solar direta ou umidade.
- Keep out of reach of children to prevent accidental ingestion of small parts or batteries.
- Ensure proper battery polarity when installing.
- Descarte as baterias usadas de acordo com os regulamentos locais.
Produto acimaview
The DAYTECH DA10 Fridge and Freezer Door Alarm is designed to alert users when a refrigerator or freezer door has been left open for a user-defined period, helping to prevent food spoilage and conserve energy.
Componentes
- Unidade principal: Contains the buzzer, LED indicator, and control buttons.
- Magnético: A smaller component that interacts with the main unit to detect door status.
- Pilhas AAA: Two AAA batteries are required and included for operation.
- Fita adesiva: For secure, tool-free installation.
Recursos do dispositivo
- Atraso ajustável: Set the alarm to trigger after 1, 2, 3, or 4 minutes.
- Two Tones: Choose between a gentle chime or a loud alarm sound.
- Volume ajustável: Five volume levels ranging from 0 dB (mute) to 120 dB.
- Aviso de bateria fraca: The device will indicate when batteries need replacement.
Configuração e instalação
Instalação da bateria
The device requires two AAA batteries for operation. These are included with your purchase.
- Locate the battery cover on the back of the main unit.
- Slide the cover open in the direction indicated by the 'OPEN' arrow.
- Insira duas pilhas AAA, certificando-se da polaridade correta (+/-).
- Deslize a tampa da bateria de volta no lugar até que ela se encaixe com segurança.
Montando o alarme
The alarm can be installed on various doors, including refrigerators, freezers, cabinets, and windows, using the provided adhesive tape.
- Clean the surface where the main unit and magnet will be installed. Ensure it is dry and free of dust or grease.
- Peel off the protective film from the adhesive tape on the back of both the main unit and the magnet.
- Attach the main unit to the door frame or the fixed part of the appliance.
- Attach the magnet to the moving part of the door, ensuring it aligns with the triangular mark on the main unit.
- Importante: The distance between the main unit and the magnet must be less than 0.98 inches (2.5 cm) when the door is closed for proper detection.
Guia de vídeo de instalação
Instruções de operação
Power On/Off and Tone Selection
The device features a single switch for power and tone selection.
- Deslize a chave para 'CHIME' for a gentle reminder tone.
- Deslize a chave para 'ALARME' for a loud, piercing alert.
- Deslize a chave para 'DESLIGADO' to power down the device.
Ajustando o volume
The volume can be adjusted to suit your environment.
- Pressione o Botão de volume (located below the CHIME/ALARM/OFF switch) to cycle through 5 volume levels: 0 dB (mute), 30 dB, 60 dB, 90 dB, and 120 dB.
Setting Delay Mode
The alarm features four delay modes, allowing you to choose how long the door can remain open before an alert sounds.
- Pressione o Tecla SET (located at the bottom of the side panel) to cycle through the four available delay modes. Each press will advance to the next mode.
| Modo | Atraso Inicial | Alarm/Chime Frequency |
|---|---|---|
| 1 | 1 minuto | Sound for 5 seconds every 15 seconds |
| 2 | 2 minutos | Sound for 10 seconds every 10 seconds |
| 3 | 3 minutos | Sound for 15 seconds every 5 seconds |
| 4 | 4 minutos | Sound for 20 seconds every 15 seconds |
Vídeo de demonstração de operação
Manutenção
Substituição da bateria
When the low battery warning sounds (5 short beeps when the door is opened), it is time to replace the batteries.
- Slide the battery cover open on the main unit.
- Remova as pilhas AAA antigas.
- Insert two new AAA batteries, observing correct polarity.
- Feche a tampa da bateria com segurança.
Limpeza
To clean the device, gently wipe the exterior with a dry, soft cloth. Do not use liquid cleaners or immerse the device in water.
Solução de problemas
- Alarme não soa: Ensure the device is powered on (not in 'OFF' mode). Check if the batteries are correctly installed and have sufficient charge. Verify that the main unit and magnet are properly aligned and within the 0.98-inch (2.5 cm) gap.
- Alarm too quiet or too loud: Adjust the volume using the volume button on the side of the main unit.
- Alarmes falsos: Re-check the alignment and gap between the main unit and the magnet. Ensure they are securely attached and not shifting.
- Aviso de bateria fraca: Replace both AAA batteries with new ones.
Especificações
- Modelo: DA10
- Fonte de energia: 2 pilhas AAA (incluídas)
- Volumetage: 3 Volts (CC)
- Método de controle: Touch (for volume/mode), Slide Switch (for power/tone)
- Tipo de montagem: Suporte de porta (adesivo)
- Tecnologia de sensores: Sensor de contato
- Dimensões (Unidade Principal): Aproximadamente 3.9 x 1.6 x 0.86 polegadas (100 x 40 x 22 mm)
- Peso do item: 7.2 onças
- Nível de som: 0-120 dB (Adjustable)
- Modos de atraso: 1, 2, 3, 4 minutos
- Cor: Branco
Garantia e Suporte
For warranty information, technical support, or any inquiries regarding your DAYTECH DA10 Fridge and Freezer Door Alarm, please refer to the contact details provided on the product packaging or visit the official Daytech website. Guarde o recibo de compra como comprovante para solicitações de garantia.
