Carnegie-Robotics -logo

Módulo Controlador de Autonomia Carnegie Robotics 55001384

Carnegie-Robotics-55001384-Autonomy-Controller-Module-product

Especificações

  • Fabricante: Robótica Carnegie
  • Número do modelo: 55001384
  • Instruções de Integração: KDB 996369 D03 OEMManual v01

Descrição

Qualcomm® Robotics RB5 Core Kit consisting of Thundercomm TurboX C865 System on Module with customization around 12GB Ram and external antennas enabled for system integration. See Qualcomm or Thundercomm hardware manuals for specifications to each product.

Instruções de integração para fabricantes de produtos host de acordo com o Manual OEM KDB 996369 D03 v01 (reconhecido pelo ISED)

Lista de regras aplicáveis ​​da FCC

  1. CFR 47 FCC PART 15 SUBPART C&E has been investigated. It is applicable to the modular. Specifically, an assessment of the worst case operating conditions has to be performed by the module integrator and tested on the host product for compliance to FCC part 15.247 and part 15.407.

Condições específicas de utilização operacional

  1. Este módulo é um módulo autônomo. Se o produto final envolver a condição de transmissão múltipla simultânea ou diferentes condições operacionais para um transmissor modular autônomo em um host, o fabricante do host tem que consultar o fabricante do módulo para o método de instalação no sistema final.
  2. Procedimentos de módulo limitado. – Não aplicável
  3. Projetos de antenas de rastreamento. – Não aplicável

Considerações sobre exposição à RF

  1. To maintain compliance with FCC’s and ISED’s RF Exposure guidelines, this equipment should be installed and operated at a minimum distance of 20cm from your body.

Antenas

  1.  This radio transmitter FCC ID: 2AMDR-55001384 / IC: 24410-55001384 has been approved by the Federal Communications Commission to operate with the antenna types listed below, with the maximum permissible gain indicated. Antenna types not included in this list that have a gain greater than the maximum gain indicated for any type listed are strictly prohibited for use with this device.
Interno

Identificação

Descrição da antena Tipo de antena Ganho máximo da antena
Antena 0** Antena Wi-Fi Antena externa 2X MIMO WIFI 2.4G Wi-Fi: 1.2 dBi,

5G Wi-Fi: 2.0dBi

Antena 1 Antena Wi-Fi Antena externa 2X MIMO WIFI 2.4G Wi-Fi: 1.2 dBi,

5G Wi-Fi: 2.0dBi

  • Bluetooth has been disabled on device and has not been tested

Antennas Tested

  • Abracon Part Number AECW0401W2-0600F_DS
  • Taoglas MA210.K.CG.001

Informações de rótulo e conformidade.

  1. The final end product must be labeled in a visible area with the following: Contains FCC ID: 2AMDR-55001384, IC: 24410-55001384

Informações sobre modos de teste e requisitos de teste adicionais

  1. The Host manufacturers are strongly recommended to confirm compliance with FCC and ISED requirements for the transmitter when the module is installed in the host.  Additional testing, Part 15 Subpart B and ICES-003 disclaimer The host manufacturer is responsible for compliance of the host system with module installed with all other applicable requirements for the system such as FCC Part 15 B and ICES-003.

Aviso da FCC

  • Quaisquer alterações ou modificações não expressamente aprovadas pela parte responsável pela conformidade podem anular a autoridade do usuário para operar o equipamento.

FCC and ISED Statements

This device complies with Part 15 of the FCC Rules and with ICES-003 of the ISED rules. Operation is subject to the following two conditions:

  1. Este dispositivo não pode causar interferência prejudicial e
  2. este dispositivo deve aceitar qualquer interferência recebida, incluindo interferência que possa causar operação indesejada.

NOTA IMPORTANTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules and ICES-003 of the ISED Canada rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reoriente ou reposicione a antena receptora.
  • Aumente a separação entre o equipamento e o receptor.
  • Conecte o equipamento em uma tomada de um circuito diferente daquele ao qual o receptor está conectado.
  • Consulte o revendedor ou um técnico de rádio/TV experiente para obter ajuda.

Statements regarding human exposure

  • With respect to radiofrequency radiation exposure Information, it is declared that this equipment complies with FCC and ISED radiation exposure limits set forth for an uncontrolled environment.
    • This equipment should be installed and operated at a minimum distance of 20 cm between the radiator and your body.
    • Este transmissor não deve ser colocado ou operado em conjunto com nenhuma outra antena ou transmissor.

Perguntas frequentes

What are the recommended distances for RF exposure compliance?

The equipment should be installed and operated at a minimum distance of 20cm from the body to comply with FCC's and ISED's RF Exposure guidelines.

Can I use antennas not listed in the manual?

Antenna types not included in the approved list are strictly prohibited for use with this device to maintain compliance.

Documentos / Recursos

Módulo Controlador de Autonomia Carnegie Robotics 55001384 [pdf] Manual de Instruções
55001384, 2AMDR-55001384, 2AMDR55001384, 55001384 Módulo Controlador de Autonomia, 55001384, Módulo Controlador de Autonomia, Módulo Controlador, Módulo

Referências

Deixe um comentário

Seu endereço de e-mail não será publicado. Os campos obrigatórios estão marcados *